This will solve most of your "Could not detect flash controller" errors.ģ. NOTE: This will make it a lot easier for you that do not solder the resistors to the board and have made your own lpt cable. *Diode MUST be soldered directly the the board, will not work in plug housing if you make your own cable!* Just ignore that they are there since you already have the diagrams up top. This diagram also shows the JTAG connections.
#How to jailbreak xbox 360 without soldering how to#
Now attaching the cable to the motherboard is easy as long as you know how to read the diagram which is pretty straight forward. All I have to do is solder it to the motherboard and I have my connection to the NAND reading and it can dump.
This is what my printer cable looks like.Īs you can see I have all the resistors soldered to the ends of the cable and the one diode attached as well. If you decide to do the same as me and not make your own cable I suggest writing down the color/pin combo so you don't have to use the multimeter again. I then wrote the color/pin combination on a piece of paper. Then used a multimeter to figure out which cable goes to which pin. I used a printer cable and cut it midway and spliced it open. We need to set up the solder connections onto the motherboard. You want to have a good clean NAND image that can be flashed back to the console if need be. Http : ///files/332755032/InpOutBinaries_1200.zip Now dumping your NAND is crucial to this. **If using a 64bit OS - Download this and Extract inpout32.dll from Win32 folder to nandpro folder. Total Commander to make sure your dumps are identical You will need the following to dump your Xbox 360 NAND. Resized to 76% (was 799 x 462) - Click image to enlargeĪlright now that you have the JTAG connections out of the way its time to install the LPT cable.